First Steps; Assembly - BRAND Dispensette TA Mode D'emploi

First Steps

Is everything in the package?
Confirm that your package includes:
Bottle-top dispenser Dispensette
valve and recirculation tube (optional), mounting tool, three bottle adapters, a performance certificate and
this operating manual.
Nominal volume, ml
Dispensette TA
®
10

Assembly

Warning:
Wear protective clothing, eye protection and gloves! Follow all safety
instructions and observe limitations of use and operating limitations
(page 26-28).
1.
Check safety ring
2.
Check sealing
washer(s)
3.
Mounting the
SafetyPrime
recirculation valve
(optional)
4.
Mounting the
Discharge tube
Note:
Recirculation valve and discharge tube must be correspondent to the
model. After two days tighten the locking nut.
Before use in trace analysis, the instrument must be thoroughly clea-
ned first. See 'Cleaning for trace analysis' (page 42).
30
TA, discharge tube, telescoping filling tube, SafetyPrime
®
Make sure that the safety ring is firmly
tightened (Fig. 1).
Before mounting the SafetyPrime
culation valve or the discharge tube make
sure that the sealing washer is always
inserted (Fig. 2).
Push the SafetyPrime
™
valve approx. 2 mm into the discharge
tube and firmly finger-tighten the locking
nut (Fig. 3). Check the SafetyPrime
recirculation valve for a tight fit.
Push the discharge tube (optional with
SafetyPrime ™
2 mm into the valve block and and firmly
finger-tighten the locking nut
(Fig. 4). Check the discharge tube for a
tight fit.
Adapters for
bottle thread
GL 28/ S 28 (ETFE), GL 32 (ETFE),
S 40 (PTFE)
™ recir-
™ recirculation
™
recirculation valve) approx.
™
recirculation
Filling tube
Length, mm
125-240
1
2
3
4