Vitalmaxx Z 09992 Mode D'emploi page 31

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Step 3: Attaching the Jumping Mat Cover
Step 4: Fitting the Support Bar
TIP: Should you have any problems attaching the cross struts (10), simply
interchange the fi ve frame parts with one drilled hole with each other.
NOTE: If you notice that the frame structure does not rest fl at on the fl oor,
you can compensate for the differences in height between the support bar
(8) and the opposite foot by inserting the four washers which are also sup-
plied (16+17). The large washers (17) can be inserted into the PVC cap of
the support bar and the small washers (16) can be inserted into the rubber
foot of the base. Following insertion, check whether the feet are in stable
contact with the fl oor. Please note: The support bar must not be longer than
the foot, i.e. the foot must not be suspended in the air!
31
1. The jumping mat cover is placed
over the rope loops from above.
2. For each leg, there is a tab on the
bottom of the cover which you pull
over the legs of the trampoline.
3. Then pull the cover on tight with the
tugs at the side and knot the tugs
onto a leg.
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sp150003

Table des Matières