Vitalmaxx Z 09992 Mode D'emploi page 22

EN
Set-Up
■ The device is only suitable for use in enclosed indoor rooms.
■ Place the device on a stable, secure, horizontal surface. Cover delicate fl oor sur-
faces (laminate, parquet fl ooring, etc.) with a non-slip protective fl oor mat where
necessary.
■ Make sure that there is clearance of at least 1 m all around the device. The training
area must be kept clear. Enough free space to allow an emergency jump-down must
be kept clear.
■ Make sure that the ceiling height of the room is suffi cient for your training purposes!
The ceiling height must be such that you cannot bump your head when you bounce
on the trampoline.
■ Keep the device away from sources of heat such as ovens or naked fl ames.
■ Do not expose the device to extreme temperatures, strong temperature fl uctuations,
direct sunlight or moisture.
Instructions for Use
■ Always inspect the device and accessories for damage and wear before use. Do not
use the device if it shows obvious signs of damage.
■ Caution! The safety level of the device can only be maintained if it is regularly che-
cked for damage. For this reason, in the interest of your own safety, inspect the
device for damage each time before you use it (look for cracks, holes, loose screws,
etc.). Defective parts must be replaced immediately by a specialist. The device may
no longer be used until it has been repaired.
■ If the device is broken, do not attempt to repair it yourself. In the event of any dama-
ge, please contact the customer service department or a specialist.
■ The device should be used only when it is properly assembled.
■ Make sure that the locking screw for locking the handle height is inserted correctly
and is locked in place.
■ Make sure that you keep your feet within the area of the jumping mat. Do not jump
on the jumping mat cover.
■ Only use the accessories that are supplied with the device.
■ Do not expose the device to extreme temperatures, strong temperature fl uctuations,
direct sunlight or moisture.
■ Leave suffi cient space on all sides of the device (at least 1 metre) so that you have
enough room to move during training.
■ Place the device on a level surface. Cover delicate fl oor surfaces (laminate, parquet
fl ooring, etc.) with a non-slip protective fl oor mat where necessary.
22