Vitalmaxx Z 09992 Mode D'emploi page 26

EN
Screws
In the following picture you can see the fastening material needed to assemble the
device:
Step 1: Assembling the Frame
1. Assemble all frame parts one after the other. Start with the frame part with the three
holes (2). The support bar will subsequently be fi tted to this part.
2. Secure the frame parts with the short screws (1), the self-locking nuts (14), one
curved washer (12) and one flat washer (13). Make sure that the curved washers
(12) are on the top side of the frame and that the fl at washers (13) are fi tted on the
underside of the frame. CAUTION: Only fully tighten the screws once the complete
frame has been locked together!
26