Vitalmaxx Z 09992 Mode D'emploi page 27

Tighten
Hold
Step 2: Attaching the Jumping Mat
CAUTION!
■ Before you fi t the jumping mat, satisfy yourself that the screws have been securely
tightened. Properly tighten them again if necessary!
Before attaching the jumping mat, please read the instructions in
this section carefully through! Make yourself familiar with the ten-
sioning tool and its use. This makes it easier for you to attach the
jumping mat!
A A
The instructions continue on the next page! Please turn over.
27
3. Tighten the screws: Hold the nut
1. First of all, the 3 rope loops with the
A
2. To do this, pull the rope loops over
3. The fi rst two loops can be pulled
A
with the spanner and tighten the
screw with the hex key. It is essen-
tial that you use the tool supplied to
tighten the screws. Self-locking nuts
cannot be tightened by hand.
yellow spheres are attached to the
frame (A).
the frame and hook the yellow sphe-
res into the loop.
over the sphere by hand, but for the
third and all other loops we recom-
mend that you use the tensioning
tool, as described in the following
steps. Note: the third rope loop with
a yellow sphere is under heavy ten-
sion but the more rope loops you at-
tach, the easier it gets.
EN