Conformity And Approval; Power Supply - IMG STAGELINE TXS-865HSE Mode D'emploi

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the transmitter TXS-865HSE complies with
the directive 2014 / 53 / EU . The EU declaration of
conformity is available on the Internet:
www .imagestageline .com
This transmitter may be operated in the following
countries:
DE
In the Federal Republic of Germany, the transmitter
requires a frequency assignment (for which a fee
is charged) .
In other countries, it is necessary to apply for a
corresponding approval . Prior to operating the
transmitter outside Germany, please contact the
MONACOR subsidiary or the corresponding au-
thorities of the respective country . Links to the
national authorities can be found via the following
Internet address:
www .cept .org
t ECC
t Topics / Info
t SRD* Regulations and indicative list of equip-
ment sub-classes
t Tools and Services
t EFIS − ECO Frequency Information System
t National Frequency Tables
*Short Range Devices

4 Power Supply

For power supply, two 1 .5 V batteries of size AA
are required .
•
Only insert two batteries of the same type and
always replace both of them .
•
If the transmitter is not in use for a longer period
of time, always remove the batteries to prevent
damage due to battery leakage .
Do not dispose of used batteries in the
household waste; always take them to
a special waste disposal, e . g . collection
container at your retailer .
Firmly press the two buttons (7) to unlock the
battery compartment cover (8) while folding up
the cover at the same time . Insert the batteries
with the positive and negative poles as indicated
in the battery compartment . Firmly close the cover
to lock it .
5 Operation
1) Connect an electret microphone designed
for operation with a pocket transmitter and
provided with a 3-pole mini XLR output to
the microphone input (3), e . g . the headband
microphone HSE-110 or the tie clip microphone
ECM-402L from IMG STAGELINE .
2) Before switching on the transmitter, set the re-
ceiver unit to an interference-free transmission
frequency ☞ instruction manual of the receiver .
3) Set the on/off switch to the position ON .
The display (1) shows the group ( . . . ),
the channel of the group and a battery symbol
indicating the current battery status in 4 levels:
full
After switching on and each time you press a
button, the green display backlight will be acti-
vated for a few seconds .
4) Via the REMOSET function, the transmitter is
automatically set to the transmission frequency
of the receiver unit . For correct operation, make
sure that
– the transmitter is not too far away from the
receiver (maximum range of REMOSET trans-
mission: 10 m)
– the automatic frequency matching for the
transmitter has been enabled
– the transmitter and the receiver unit have
been set to the same identification number
☞ chapter 5 .1 .4
– the transmitter is not locked
Check the settings on the transmitter and cor-
rect them, if necessary . Then activate the REMO-
SET function on the receiver unit
manual of the receiver . When the frequency is
matched, the display backlight on the transmit-
ter is blue . The display briefly shows
the transmitter will be set to the channel and
the channel group of the receiver unit .
Manual setting of the channel group and
the channel on the transmitter is also possible
chapter 5 .1 .1 .
☞
5) Speak / sing into the microphone or, in case of
an instrument microphone, feed an audio signal
to the microphone . The display of the receiver
unit shows the volume level of the microphone .
To readjust it, change the sensitivity
5 .1 .2 .
discharged
☞ chapter 5 .1 .3
☞ chapter 5 .1 .5
☞ instruction
and
☞ chapter
9