Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Please unfold page 3. Then you can always
see the operating elements and connections
described in the figures.
1 Operating Elements
and Connections
1 Transmitting antenna
2 Power switch
3 LC display; indicates the transmission fre-
quency and the charging status of the batte-
ries during operation
4 Mini XLR connection for a headband micro-
phone or a tie-clip microphone
5 Key
for increasing the frequency (in the
frequency adjusting mode) and for activat-
ing the lock function (in the lock mode)
6 Key
for reducing the frequency (in the fre-
quency adjusting mode) and for deactivat-
ing the lock function (in the lock mode)
7 Key SET
with the unit not locked:
to recall and exit the adjusting modes for
frequency and lock function
5.1 and 5.2.1
with the unit locked:
to recall and exit the adjusting mode for
the lock function
8 Locking for the control part:
to unlock the control part, press down the
two latching buttons so that it unlocks and
can be displaced upwards (figs. 1, 2) or
downwards (fig. 3)
9 Belt clip (can also be mounted if it is turned
by 90° or 180°)
10 Gain control; for matching the input sensi-
tivity turn the control with the supplied ad-
justing key
11 Battery compartment for two 1.5 V batteries
of size AA (R6)
→
chapters
→
chapter 5.2.2
2 Important Notes
The unit is suitable for indoor use only. Pro-
tect it against dripping water and splash
water, high air humidity, and heat (admissible
ambient temperature range 0 – 40 °C).
For cleaning only use a dry, soft cloth, by no
means chemicals or water.
No guarantee claims for the unit and no lia-
bility for any resulting personal damage or
material damage will be accepted if the unit is
used for other purposes than originally in-
tended, if it is not correctly operated or not re-
paired in an expert way.
If the unit is to be put out of operation defini-
tively, take it to a local recycling plant for a dis-
posal which is not harmful to the environment.
Do not put exhausted batteries/defective rechargeable
batteries into the household rubbish but take them to a
special waste disposal (e. g. collective container at your
retailer).
3 Applications
This multifrequency pocket transmitter is pro-
vided for connecting a headband microphone or
tie-clip microphone. In combination with the
multifrequency receiver TXS-870 from "img
Stage Line", it makes up a wireless audio trans-
mission system. Within the UHF frequency
range of 790 – 814 MHz, the transmission fre-
quency can be selected as desired (frequency
spacing 125 kHz).
3.1 Conformity and approval of the
transmitter
Herewith, MONACOR INTERNATIONAL de-
clare that the unit TXS-870HSE is in accord-
ance with the basic requirements and the other
relevant regulations of the directive 1995/5/EC.
The declaration of conformity can be found in
the Internet via the MONACOR INTERNA-
TIONAL home page (www.imgstageline.com).
The approval number is
This unit may be operated in the following coun-
tries:
DE, DK, AT
The regulations of the country where this unit is
operated must always be observed. These reg-
ulations can be found via links to the national
authorities from the following Internet address:
www.ec.europa.eu/enterprise/rtte/weblinks.htm
0197
.
!
GB
7
Publicité
Table des Matières
