Pocket Transmitter
These instructions are intended for users with-
out any specific technical knowledge . Please
read these instructions carefully prior to opera-
tion the unit and keep them for later reference .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Overview
1 Transmitting antenna
2 Power switch
3 LC display; indicates the transmission fre-
quency and the charging status of the bat-
teries during operation
4 Mini XLR connection for a headband
microphone or a tie-clip microphone
5 Key
for increasing the frequency (in the
frequency adjusting mode) and for activat-
ing the lock function (in the lock mode)
6 Key
for reducing the frequency (in the
frequency adjusting mode) and for deacti-
vating the lock function (in the lock mode)
7 Key SET
with the unit not locked:
to call up and exit the adjusting modes for
frequency and lock function
chapters 5 .1 and 5 .2 .1
☞
with the unit locked:
to call up and exit the adjusting mode for
the lock function
8 Locking for the control part: to unlock the
control part, press down the two latch-
ing buttons so that it unlocks and can be
moved upwards (figs . 1, 2) or down wards
(fig . 3)
9 Belt clip (can also be mounted when it is
turned by 90° or 180°)
10 Gain control; for matching the input sensi-
tivity, turn the control with the supplied ad-
justing key
11 Battery compartment for two 1 .5 V batter-
ies of size AA (R6)
chapter 5 .2 .2
☞
2 Important Notes
This unit corresponds to all relevant directives
of the EU and is therefore marked with
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water and splash wa-
ter, high air humidity and heat (admissible
ambient temperature range 0 – 40 °C) .
•
For cleaning only use a dry, soft cloth, never
use chemicals or water .
•
No guarantee claims for the unit and no lia-
bility for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not correctly connected or
operated or if it is not re paired in an expert
way .
If the unit is to be put out of oper-
ation definitely, dispose of the unit
in accordance with local regulations .
3 Applications
This multifrequency pocket transmitter is pro-
vided for connecting a headband microphone
or tie-clip microphone . In combination with
the multifrequency receiver TXS-875 from
IMG STAGELINE, it makes up a wireless audio
transmission system . Within the UHF frequency
range of 518 – 542 MHz, the transmission fre-
quency can be selected as desired (frequency
spacing 125 kHz) .
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the product TXS-875HSE complies with
the directive 2014 / 53 / EU . The EU declaration
of conformity is available on the Internet:
www .img-stageline .com
Restrictions or requirements apply in the
following countries:
CZ
IT
The regulations of the country where the prod-
uct is operated must always be observed . Prior
to operating the product, please contact the
MONACOR subsidiary or the corresponding
EL
FI
FR
LT
MT
PL
.
7