Hauff-Technik ESH Instructions De Montage page 8

Raccordements de tube
Masquer les pouces Voir aussi pour ESH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Rohranschlüsse für ESH/MSH-PolySafe/MSH-FW/ESH/
MSH-FUBO
Safety instructions and information
Target group
The installation may only be carried out by technical experts.
Qualifi ed and trained individuals carrying out installation must have
• knowledge of general safety and accident prevention regulations as amended,
• knowledge of how to use safety equipment,
• knowledge of how to use hand tools and electric tools,
• knowledge of the relevant standards and guidelines for laying pipes/cables and
for backfi lling utility trenches as amended,
• knowledge of the regulations and installation guidelines of the supply company
as amended,
• knowledge of the waterproof concrete directive and building waterproofi ng
standards as amended.
General information and intended use
In line with their intended use, our products have been developed solely for instal-
lation in buildings made of state-of-the-art materials. Insofar as no express written
confi rmation has been provided by us, we do not accept any liability for any other
purposes or purposes going beyond the above.
For warranty conditions, please see our current General Terms and Delivery Conditions.
Gastight and watertight pipe connections are suitable for connecting Hatefl ex
spiral hoses as well as for smooth or corrugated cable ducts in single-line/multi-line
building entries.
Safety
This section provides an overview of all the main safety aspects for optimum protec-
tion of personnel and a safe installation process. If there is a failure to observe the
instructions and safety information set out here, this may result in signifi cant hazards.
When installing pipe connections, it is imperative to observe the relevant professional
association rules, the VDE provisions, the relevant national safety and accident pre-
vention regulations and your company's guidelines (work and procedure instructions).
The fi tter must wear the relevant protective clothing.
Only intact components may be installed.
The following instructions are to be observed prior to installati-
on of the pipe connections:
on of the pipe connections:
WARNING!
Risk of injury in the event of improper installation!
Improper installation can result in signifi cant bodily harm and property damage.
• The nationally applicable laying and fi lling regulations for pipes and cables are
to be observed at all times.
• Seal the underground and pipe substructure well prior to laying pipes/cables so
that the latter cannot subside.
NOTE!
No sealing due to incorrect installation!
Improper installation can result in damage.
• The norms and directives referred to here are valid in Germany only. In all other
countries, the national norms and directives are to be observed as amended.
• No cleaning agents containing solvent may be used to clean the pipe connections.
We recommend using the cable cleaner KRMTX.
• For details of other accessories and further information, see www.hauff-technik.
de and the technical data sheets.
Personnel requirements
Qualifi cations
WARNING!
Risk of injury in case of inadequate qualifi cation!
Improper handling can result in signifi cant bodily harm and property damage.
• Installation may only be carried out by qualifi ed and trained individuals who
have read and understood these instructions.
Skilled experts
Based on their specialist training, skills, experience and familiarity with the relevant
provisions, standards and regulations, skilled experts are able to carry out the work
assigned, independently identifying and avoiding potential hazards.
Transport, packaging, scope of delivery and storage
Safety instructions in connection with transport
Safety instructions in connection with transport
NOTE!
Damage in the event of improper transport!
Signifi cant damage can occur in the event of improper transport.
• When unloading packaging items on delivery and in the course of in-house transport,
proceed with care and observe the symbols on the packaging.
Transport inspection
Inspect the delivery immediately on receipt for completeness and transport damage.
In the event of transport damage being visible from the outside, proceed as follows:
8
• Do not accept the delivery or only do so subject to reservations.
EN
• Make a note of the extent of damage in the transport documentation or delivery
note provided by the transporter.
Delivery scope
The scope of delivery of the four-part pipe connection set DN75 comprises:
1 double sleeve DN75
3 profi le sealing rings DN75
The scope of delivery of the transition piece UAD75/82.5 comprises:
1 adapter UAD75/82.5
1 wedge sealing ring
The scope of delivery of the pipe connection/adapter sleeve MA75-90/75-90
comprises:
1 connection/adapter sleeve MA75-90/75-90
2 stainless steel clamping straps
The scope of delivery of the transition sleeve UMS75-90/102-125 comprises:
1 transition sleeve UMS75-90/102-125
2 stainless steel clamping straps
The scope of delivery of the branch sleeve AMS3x75 comprises:
1 branch sleeve AMS3x75
3 stainless steel clamping straps
Storage
NOTE!
Damage due to improper storage!
Signifi cant damage can occur in the event of improper storage.
Disposal
If no return or disposal agreement has been concluded, recycle dismantled components
after they have been properly dismantled:
• Metal remains are to be scrapped according to existing environmental regulations.
• Dispose of elastomers according to existing environmental regulations.
• Dispose of plastics according to existing environmental regulations.
• Dispose of packaging material according to existing environmental regulations.
Art. Nr.: 5090033071
Rev.: 01/2020-01-21
• Submit a claim for every defect as soon as it has been identifi ed.
• Claims for damages can only be asserted within the applicable claim period.
Protect the pipe connections from damage, damp and soiling prior to installation.
Only intact components may be installed.
The pipe connections must be stored in such a way that they are not exposed
to low temperatures (<5° C), high temperatures (>30° C) or direct sunlight.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Msh-polysafeMsh-fwMsh-fubo

Table des Matières