Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
EXTERNAL
The camera can be powered from an external 12 volt DC input such
as a 12 volt battery (BATT-12/KIT-12V, sold separately) or a 12 volt
adapter (AD-12V, sold separately). When using a 12 volt connection,
we recommend removing the AA batteries to prevent surcharges.
During the installation of a 12 volt connection, place the switch inside
the battery case to "ALK" (i.e. alkaline). If combined with a lithium
battery pack, slide the switch to "LIT-09". To find the accessories
available for the 12 volt power supply, see "Options".
SOLAR PANEL
This model offers the possibility of a connection to a solar panel
SP-12V (sold separately, see "Options") to maintain the charge
of the lithium battery pack LIT-09/LIT-C-8 (sold separately, see
"Options"). During the installation of the rechargeable lithium
battery pack, slide the switch inside the battery case to "LIT-09" to
activate the charging system of the solar panel.
MEMORY STORAGE
Using a memory card (sold separately, see "Options") is required
to operate the camera. When the "Photo" or "Video" mode is
selected, the screen displays "No memory card" if no memory card
is present. The camera is compatible with SD/SDHC memory card,
up to 32 GB capacity. Before inserting or removing a memory card,
the camera must be turned off. Failing to do so may cause loss of
pictures or damage the pictures already recorded on the memory
card. When the SD card is full, the viewing screen indicates
"Memory card full" when the "Photo" or "Video" mode is selected.
The used space on the memory card is displayed as percentage in
the upper right corner of the screen when the camera is in "Test"
mode. The following data shows the approximate quantity of photos
or video length that can be taken by the camera depending on the
memory card capacity.
2.0 GB
Photo
8 MP
1190
Video
640 x 480
65 min
4.0 GB
8.0 GB
32 GB
2380
4760
19040
2h10
4h10
16h40
« BUSY » LED
The « BUSY » light, located next to the screen, lights up when
the camera is recording.
MAIN MENU
▲
▼
Use the "
" and "
" button to navigate the interface or to modify
a selection, the "OK" button to select and the "BACK" button to
return to the previous menu.
PHOTO
Allows the camera to take pictures in Standalone, Cellular or
Security mode (see "Settings Menu" for details).
When "Photo" mode is selected, the test light on
Standalone:
the front of the camera flashes for 60 seconds to allow the user to
leave the area without being photographed. A countdown is also
displayed on the screen during boot time.
When "Photo" mode is selected, the camera
Cellular/Security:
connects to the
mySPYPOINT
connection status on the screen. The test light on the front of the
camera flashes for 60 seconds to allow the user to leave the area
without being photographed. A countdown is also displayed on the
screen during boot time.
Note: If communication is not established, the "Photo" mode is
defused and an appropriate error message is displayed on the screen.
(See "Error Message" section for details)
VIDEO
Allows the camera to record movies in Standalone mode only.
(see "Settings Menu" for details).
When "Video" mode is selected, the test light on the
Standalone:
front of the camera flashes for 60 seconds to allow the user to leave
without being filmed. A countdown is also displayed on the screen
during boot time.
If the camera is set to Cellular or Security
Cellular/Security:
mode, a message indicates that the camera will be transferred in
Standalone mode and then boots up normally.
9
service and displays the
Publicité
Table des Matières
