Vacuum Hose Maintenance - Tennant T1 Manuel D'utilisation

For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
4. Wipe the squeegee blades (Figure 32). Replace
the blades if worn or damaged. Remove any
clogged debris inside both inlet openings.
FOR SAFETY: Before tilting machine, turn the main
power switch to the off position and empty tanks.
FIG. 32
5. Clean the machine with an all purpose cleaner and
damp cloth (Figure 33).
FOR SAFETY: When cleaning machine, do not
power spray or hose off machine. Electrical
malfunction may occur.
FIG. 33
6. Clean the solution hose screen (Figure 34).
FIG. 34
Tennant T1 (03- 11)
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net

VACUUM HOSE MAINTENANCE

To prevent debris buildup in vacuum system, flush
vacuum hose as described below:
1. Place machine over floor drain and turn the main
Inlet
Openings
2. Place a dry towel over the vacuum intake screen to
3. With water turned off, insert a garden hose into the
4. Slowly turn on water to prevent back- splash if
NOTE: The vacuum hose is Y- shaped. Make sure to
flush out both sides (Figure 38).
English
power switch to the off position (Figure 35).
FIG. 35
prevent water from entering vacuum motor (Figure
36).
vacuum intake hose as shown (Figure 37).
FIG. 36 FIG. 37
vacuum system is clogged. Increase water
pressure to flush out debris buildup.
FIG. 38
EN
13