General hazardous situations.
To prevent injury, ensure that:
• the system cannot be activated unintentionally.
• Installation and repair work may be carried out by
authorized technicians only and with the appropriate
tools.
• After an interruption in the power supply or pneu-
matic supply, ensure that the process is restarted in a
defined or controlled manner.
• The device may be operated only when in perfect condi-
tion and in consideration of the operating instructions.
• The general rules of technology apply to application
planning and operation of the device.
english
8
5.
general infOrmaTiOn
5.1. contact address
germany
Bürkert Fluid Control Systems
Sales Center
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel.: +49 (0)7940 - 10 91 111
Fax: +49 (0)7940 - 10 91 448
E-mail: info@de.burkert.com
international
Contact addresses can be found on the final pages of the
printed operating instructions.
And also on the internet at:
www.burkert.com
5.2. Warranty
The warranty is only valid if the solenoid valve Type 6014 is
used as authorized in accordance with the specified appli-
cation conditions.
5.3. information on the internet
The operating instructions and data sheets for Type 6014 can
be found on the Internet at:
www.burkert.com
english
10
The solenoid valve Type 6014 was developed with due
consideration given to the accepted safety rules and
is state-of-the-art. However, dangers can still arise.
Failure to observe this operating manual and its operating
instructions as well as unauthorized tampering with the
device release us from any liability and also invalidate the
warranty covering the device and accessories!
4.1. models with explosion
protection
Danger!
Danger of explosion!
Improper use in the potentially explosive area may result in
an explosion.
• Also follow the specifications in the certificate of
conformity.
• If models have ATEX approval, also follow the specifica-
tions in the ATEX instructions.
6.
sysTem descripTiOn
6.1. general description
The direct-acting solenoid valve Type 6014 is available in
two designs.
Type 6014 is used for the blocking,
dosing, filling and venting of neutral
gaseous and liquid media, in particular
for controlling single-acting pneumatic
drives or technical vacuum. The modular
designed valve can be installed individually
or in a block on the multiple manifold.
Type 6014P is used as a special pilot valve
for direct installation on the externally con-
trolled pneumatic drives. It consists of the
magnetic drive Type 6012 and a special
connection body with hollow screw which
can be connected directly to the control air
connection of the drive. The valve features
manual actuation as standard.
Type 6014
english
9
9
english
11
11