Burkert 6014 Manuel D'utilisation page 7

9. mainTenance,
TrOubleshOOTing
9.1. safety instructions
Danger!
Risk of injury from high pressure in the equipment!
• Before loosening the lines and valves, turn off the pres-
sure and vent the lines.
Risk of injury due to electrical shock!
• Before reaching into the system, switch off the power
supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety
regulations for electrical equipment!
Risk of burns/Risk of fire if used continuously
through hot device surface!
• Keep the device away from highly flammable sub-
stances and media and do not touch with bare hands.
english
24
10. disassembly
10.1. safety instructions
Danger!
Risk of injury from high pressure in the equipment!
• Before loosening the lines and valves, turn off the pres-
sure and vent the lines.
Risk of injury due to electrical shock!
• Before reaching into the system, switch off the power
supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety
regulations for electrical equipment!
Warning!
Risk of injury from improper disassembly!
• Disassembly may be carried out by authorized techni-
cians only and with the appropriate tools!
english
26
Warning!
Risk of injury from improper maintenance!
• Maintenance may be carried out by authorized techni-
cians only and with the appropriate tools!
Risk of injury from unintentional activation of the
system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following maintenance, ensure a controlled restart.
9.2. malfunctions
If malfunctions occur, check
→
the line connectors
→
the operating pressure
→
the supply voltage and valve control
If the valve still does not switch, please contact your
Bürkert Service.
10.2. disassembly
→
Turn off the pressure and vent the
→
Switch off the power supply.
→
Loosen the cable plug.
Valve with threaded connection:
→
Hold the device with a suitable tool (Open-end wrench)
on the body and screw off the pipeline.
Valve with flanged connection:
→
Loosen the nut on the coil and remove coil.
→
Loosen the body from the manifold
Type 6014
english
25 25
lines.
english
27 27