Replacing The Gas Spring - Release Mechanism - Bowden Cable For Seat Tilting (Ocean Vip / Ocean Dual Vip) - Invacare Aquatec Ocean Manuel De Maintenance

Aquatec® Ocean/Ocean Ergo family
5.10 Replacing the gas spring — release mechanism — Bowden cable for seat tilting
(Ocean VIP / Ocean Dual VIP)
Wrench (6, 8) / Allen key (4 mm) / Snap ring pliers
1. Loosen the nut B on the distributor C completely and
turn it all the way up. Turn the upper piece into the
distributor.
2. Loosen the nut D on the release mechanism E and
turn it all the way up. Unscrew threaded piece F from
the release mechanism.
Pull slightly the Bowden cable A upwards to
make it easier.
3. Unhook the Bowden wire head G.
If the activation handle / Bowden cable has to be replaced refer to chapter 5.9 Replacing the gas spring — release
mechanism — Bowden cable for backrest tilting (Ocean Dual VIP / Ocean Dual VIP Ergo), page 17.
1. If the release mechanism A has to be replaced: Loosen
nut B.
2. Remove circlip C.
3. Remove the gas spring E from the bolt D.
4. If the entire gas spring is to be replaced, also remove the
upper circlip and bolt G and remove the gas spring E.
5. If the release mechanism has to be replaced: Turn down
the release mechanism A from the threaded piece F.
22
■■■
1640651-A