cascade corporation G Série Instructions D'installation page 8

I
NSTALLATION
6
Mount clamp on truck carriage
A
Center the truck behind the clamp.
B
Tilt mast forward and raise carriage into
position.
C
Engage upper mounting hooks with carriage.
28G (Current Models) – Make sure centering
tab engages center notch on the top carriage
bar.
28G (Earlier Models), 36G-140G – Make
sure the locator tab on the left upper hook
engages the closest notch on the top
carriage bar.
D
Lift clamp 5 cm (2 in.) off pallet.
ITA Class II – 15–17 mm (0.60–0.66 in.)
ITA Class III – 18–20 mm (0.72–0.78 in.)
ITA Class II – 8–9 mm (0.32–0.36 in.)
ITA Class III – 10–11 mm (0.39–0.43 in.)
7
Install and engage lower hooks
BOLT-ON TYPE
Tap tight
into position
Tighten capscrews:
28G (Current Models) – 165 Nm (122 ft.-lbs.)
CL II/III – 225 Nm (166 ft.-lbs.)
CL IV – 390 Nm (287 ft.-lbs.)
6
C
Engage
Notch
locator tab
Truck Upper
Carriage Bar
GA0079.eps
Lower
Carriage
Bar
S T
J U
A D
Slide hook
up to engage
bar, install
pin in locked
position.
(upper hole.)
RC0148.eps
Centering Tab
Back (Driver's) View
28G (Current Models)
IMPORTANT: Hoses
must be connected to
clamp supply fittings.
Back (Driver's) View
28G (Earlier Models) 36-77G
QUICK-CHANGE TYPE
Lower
Carriage
Bar
®
e
a d
s c
c a
RR0515.eps
CL2867.eps
Inspect hooks for
excessive clearance.
(Reverse guides to
reduce clearance –
refer to Step 2.)
5 mm
(3/16 in.)
Max.
RC0147.eps
6038011-R4 EN