cascade corporation G Série Instructions D'installation page 5

I
NSTALLATION
3
Prepare hoses
A
Determine hose lengths required for hydraulic
supply configuration of truck.
B
Cut hoses to length, install end fittings.
28G (Current Models)
Clamp
28G (Earlier Models), 36G-77G
RH & LH 2-PORT THINLINE
Clamp
6038011-R4 EN
Rotate CCW
Open Rotate CW
CL5341.eps
HOSE REELS
™
Rotate CCW
Open Rotate CW
CL2864.eps
CAUTION: Rotate function supply circuit back
pressure exceeding 35 bar (500 psi) can result
in excessive oil heating, reduced attachment
performance and shortened hydraulic system life.
Check for restrictions such as numerous fittings
and fitting/hose sizes less than No. 6 (28G Current
Models) or No. 8. (28G Early Models, 36G-140G).
CAUTION: Use hoses that are 180 bar (2600 psi)
working pressure rated for all attachment functions.
IMPORTANT: Revolving connection end block
may be oriented for bottom-arm shut off (normal)
or top-arm shut off. End block is cross-drilled to
enable supply connections to be plumbed from
either side.
RH 2-PORT THINLINE
™
SINGLE INTERNAL HOSE REEL
Clamp Rotate CCW
Open
Revolving
Connection
End Block
HOSE REEL AND
Rotate CW
CL2865.eps
"X" on top for
bottom-arm
shut-off
(shown)
"X" on bottom
for top-arm
shutoff
CL3022.eps
3