cascade corporation G Série Instructions D'installation page 3

T
RUCK REQUIREMENTS
WARNING: Rated capacity of the truck/
attachment combination is a responsibility of
the original truck manufacturer and may be less
than that shown on the attachment nameplate.
Consult the truck nameplate.
Truck Relief Setting
Low Pressure
155 bar (2245 psi)
189 bar (2740 psi)
NOTE: The attachment revolving connection has separate
pressure relief control, see Instruction Step 12 for adjustment.
Truck Flow Volume
28G, 36G, 44G,
52G,64G
70G, 77G
120G, 140G
➀ Cascade Revolving Clamps are compatible with SAE 10W petroleum
base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or MIL-0-2104B.
Use of synthetic or aqueous base hydraulic fluid is not recommended.
If fire resistant hydraulic fluid is required, special seals must be used.
Contact Cascade.
➁ Flow less than recommended will result in reduced system
performance.
➂ Flow greater than maximum can result in excessive heating, reduced
system performance and short hydraulic system life.
Carriage Mount Dimension (A) ITA (ISO)
A
Class II
Class III
Class IV
GA0028.eps
Auxiliary Valve Functions
Check for compliance with
ISO (ANSI) standards:
6038011-R4 EN
(see attachment nameplate)
High Pressure
190 bar (2755 psi) Recommended
250 bar (3625 psi) Maximum
➀
Min. ➁ Recommended
18 L/min. 37 L/min.
(5 GPM) (10 GPM)
26 L/min. 45 L/min.
(7 GPM) (12 GPM)
38 L/min. 57 L/min.
(10 GPM) (15 GPM)
Minimum
380.0 mm (14.94 in.) 381.0 mm (15.00 in.)
474.5 mm (18.68 in.) 476.0 mm (18.74 in.)
595.5 mm (23.44 in.) 597.0 mm (23.50 in.)
GA0082.eps
Hoist Up
Max. ➂
56 L/min.
(15 GPM)
75 L/Min.
(20 GPM)
90 L/Min.
(24 GPM)
Maximum
Tilt Rotate
Forward CCW
Hoist Down Open
Clamp
Tilt Rotate
Back CW
GA0380.eps
Carriage –
Clean carriage bars
and inspect carriage bars. Make sure
the bars are parallel and that ends are
flush. Repair any damaged notches.
1