Enviracaire HCL-1260RE Mode D'emploi page 9

TROUBLESHOOTING
Fault
The air conditioner does not function when it
is switched on at the ON/OFF power key.
The compressor functions but goes off
after a short time..
Poor cooling function
Clicking noise in the air conditioner
The air conditioner will not function and the
Standby control lamp is flashing.
The air conditioner will not function and the
TIMER control lamp is flashing.
The compressor stops and the water-tank
control lamp „ALM" lights up.
Purchasing condition:
As a condition of purchase, the purchaser assumes responsibility for
the correct usage and care of this air conditioner. The buyer or user
must decide for himself or herself, when and for how long the air
conditioner is in use.
ENGLISH
Possible cause
1. The water tank lamp is flashing, the water
tank is full.
2. The 3 minutes have not elapsed since the
air conditioner was switched off.
3. The room temperature is lower than the
programmed temperature (operating mode
COOL).
4. The air conditioner is not plugged in.
5. The power current is too weak.
6. The batteries in the remote control are
empty.
The air intake vents are blocked.
1. The air filters are blocked or soiled, or the
air intake vents are blocked.
2. There is a heat source in the room or it is
crowded
3. Windows or doors are open.
4. The temperature setting is too high.
Plastic parts in the appliance expand or
shrink during changes in temperature.
The sensor is faulty.
A problem with the cable system.
The water pump is not working or the water
drainage tube is blocked
WARNING: IF THERE ARE PROBLEMS WITH THE AIR
CONDITIONER, PLEASE FOLLOW THE INSTRUCTIONS IN
THE GUARANTEE CONDITIONS. DO NOT ATTEMPT TO
OPEN OR REPAIR THE AIR CONDITIONER YOURSELF AS
THIS COULD LEAD TO THE GUARANTEE BECOMING NULL
AND VOID, AND COULD CAUSE HARM TO PERSONS AND
POSSESSIONS.
Technical modifications reserved.
9
Correction
1. Empty the water tank.
2. Wait until the 3 minutes have elapsed.
3. Reset the temperature.
4. Plug the air conditioner into a power
socket.
5. Check the power current.
6. Change the batteries.
Remove the objects that are blocking the air
intake vents and clean the air filters.
1. Clean the air filters. Remove the objects
that are blocking the air intake vents.
2. Remove the heat source
3. Close windows and doors.
4. Set a lower temperature.
This is normal. The noise disappears as soon
as the difference in temperature is equalized.
Ask an expert.
Ask an expert.
Follow the instructions in the guarantee
conditions.