Installing The Chain Counter - MZ electronic EV-030 Instructions D'utilisation

Installing the chain counter

(see connection diagram)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO
INSTALLATION.
•
The chain counter must be positioned so that the display will be easy to read. It
should not be exposed to direct sunlight.
•
The rear part of the instrument must be protected from contact with water or
moisture.
•
The instrument may be fastened to dashboards of any thickness. The screws
used for clamping must be of the self-threaded kind and with a diameter of 3.5
mm (~9/64") and a maximum length of 10 mm plus the thickness of the
dashboard.
•
In the part to the rear of the dashboard there must be minimum clearance of 35
mm (1" 3/8) and there must also be adequate access to perform installation and
maintenance work.
•
On the dashboard make a hole with a diameter of 30 mm (~ 1" 3/16), as
indicated, and 4 holes with diameters of 4 mm (~5/32") for the chain
counter clamping screws. Use cutting nippers to cut the
three pins on the back of the instrument, position
the chain counter and fasten it to the dashboard
by tightening the four screws. If the
dashboard already has a hole with a 54 mm
(2"1/8) diameter, it is not necessary to
cut the pins on the back.
•
The seal must be
positioned
between the chain
counter and the
dashboard.
EV-030
29
English
Rev. 07 – 2008