Installing The Chain Counter - MZ electronic WHC040 Instructions D'utilisation

Installing the chain counter

(see connection diagram at page 73/74)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO INSTALLATION.
Connections
Sensor holes
WHC040
12-poles Terminal Block in the receiver
PIN
POS - Battery
NEG +Battery
UP UP Command
DOWN DOWN Command
SW-M Magnetic sensor (1st wire)
SW-M Magnetic sensor (2nd wire)
BO-L Bow Left Command
BO-R Bow Right Command
ST-L Stern Left Command
ST-R Stern Right Command
CAN-H CAN-H signal (CanOpen serial interface)
CAN-L CAN-L signal (CanOpen serial interface)
sensore magnetico
magnetic sensor
4
min.44 mm(1"3/4)
SEGNALE
19
English
Rev. 02-2021