MZ electronic EV-030 Instructions D'utilisation page 41

Once the "Sensor Detection" function has recognised a "Standard" type sensor
instead of a "Project" sensor, when the "Sensor Calibrat." menu is entered again,
the menu options will "configure" themselves according to the sensor detected.
Standard and X.. Project series
sensor menu
(magnet and sensor placed
on barbotin)
Sensor Calibrat
Barb. Circ.
E x i t
Barbotin Circumference
In this row the user must enter the
circumference of the gipsy (in
centimetres or inches). Use the Table 1
provided to calculate the
circumference.
Settable values: centimetres or inches.
Default value, 33 cm.
Select with
Select value with
Confirm with
Exit
To return to the settings menu.
EV-030
1000 – 1500 –2000 W Project series
(magnet and sensor placed
Sensor Calibrat
3 3 . 0 Red. Factor
E x i t
Reduction Factor
In this row the user must enter the
reduction factor. See next Table 2 for the
correct value to be entered
Default value, 57.
Confirm with
41
English
sensor menu
on motor)
5 7 . 0
Rev. 07 – 2008