MZ electronic EV-030 Instructions D'utilisation page 34

Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED': indicates the chain speed during hoisting or lowering in meters per
minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage.
ICONS: this is the part of the display bearing the icons that indicate the hoisting
or casting of the anchor and any failure.
When the instrument is turned on for the first time, it will set up as programmed
in the factory (see table).
EV-030
Parameter
Up Alarm
Auto Down
BackLight Time
Units of measurement
Chain Measure
Barbotin Circumference
Sensor type
Keyboard Beep
Language
Works Hours
Rope_Chain
Default value
3.0 metres
Off
30 seconds
Metres/centimetres
0.0 metres
33 cm
unknown
Yes
Italian
0
Off
34
English
Rev. 07 – 2008