Leica SF 64 Mode D'emploi page 69

Setting procedure
1. Press the button 13 repeatedly until the
selection menu appears
2. Press the sensor button on the touch display
SET
3. Use / to move to the central field
▲ ▼
ZOOM
outlined in red
4. Press
ZOOM
5. Use / to move the desired focal length to the
▲ ▼
central field outlined in red
6. Press selected focal length
The setting takes effect immediately.
The following zoom positions are possible for the
reflector. 24-28-35-50-70-85-105-135-180-200mm
Tip:
If you do not always need the full guide number and
range of the flash unit, you can leave the reflector
position at the lowest focal length of the zoom lens.
This guarantees that the edges of the pictures are
completely illuminated. This spares you continuous
adjustment to the lens focal length.
Example:
You are using a zoom lens with a focal length of 24 to
90mm. In this example, set the position of the flash
unit reflector to 24mm.
Resetting to auto zoom
1. Touch the camera shutter release so that data is
exchanged between the flash unit and camera
2. Press the button repeatedly until the selection
menu appears
3. Press the sensor button on the touch menu
SET
4. Use ▲ / ▼ to move to the central field
ZOOM
outlined in red
5. Press
ZOOM
6. Use / to select
▲ ▼
A.ZOOM
7. Press
A.ZOOM
After approx. 10s the system switches to mode
display, or press button repeatedly until the
mode display appears.
EN
69