The Selection Menu - Leica SF 64 Mode D'emploi

EN TURNING THE FLASH UNIT ON AND OFF
Switch on the fl ash unit with the
• The start screen appears. When the fl ash is ready,
The fl ash unit then always switches on in the mode
most recently used (e.g. manual mode
• In standby mode, the
To switch off , press the
out.
Note:
If the fl ash unit is not being used for a prolonged
period, we recommend:
Switch the fl ash unit off with the
remove the power sources (batteries)

THE SELECTION MENU

Press the
menu appears
The selection menu is broken down into 6 sensor
buttons:
After the
the modes.
–
–
–
–
–
56
button
the button 12 lights up green
button
13
button until all displays go
button and
button repeatedly until the selection
13
button has been pressed, you can set
MODE
, see p. 62
TTL
, see p. 63
A
, see p. 65
M
, see p. 66
STROBO
, see p. 70
M-SLAVE
16
).
M
fl ashes red.
After the button has been pressed, you can set
SET
the fl ash parameters.
see p. 65
– (partial light output),
P
– (exposure compensation), see p. 64
EV
– (refl ector position), see p. 68
ZOOM
– (No. of fl ashes), see p. 66
N
– (fl ash frequency), see p. 67
f
– (shutter)
F
– (light sensitivity)
ISO
Display of the fl ash parameters depends on the fl ash
mode selected.
After the button has been pressed, the
SERVICE
touch display can be confi gured or the fl ash unit can
be reset to factory settings.
– , see p. 86
BRIGHTNESS
– , see p.86
ROTATION
– , see p. 87
RESET