Leica SF 64 Mode D'emploi page 58

EN AUTOMATIC DEVICE SHUTDOWN
At the factory, the fl ash unit has been set so that it
switches to standby mode approx. 10 minutes -
– after switching on,
– after triggering a fl ash,
– after touching the camera shutter release button,
– after switching off the camera exposure measuring
to save energy and to protect the power sources from
accidentally discharging.
• The active automatic device shutdown is also
• Furthermore, the following also go out:
• The
The most recently used mode setting remains stored
after automatic shutdown and is immediately
available again when the device has been switched
back on.
The fl ash unit is switched back on by pressing the
button or by briefl y touching the camera shutter
release (wake-up function).
Notes:
• In
• If the fl ash unit is not needed for a prolonged
• If necessary, automatic shutdown can be activated
• The fl ash unit switches off completely approx.
58
system
displayed.
– the fl ash readiness display
12
– the displays on the LCD screen
button 13 fl ashes red.
mode automatic device shutdown is
M-Slave
not active.
period, it should always be switched off with the
button 16 !
or switched off after just 1 minute.
one hour after the last use.
• In all modes, the screen is set to half-brightness
after approx. 10s to save energy. Pressing any
button or tipping on the screen will restore normal
brightness.
SETTING AUTOMATIC DEVICE SHUTDOWN
Switch on the fl ash unit with the
• The start screen appears.
The fl ash unit then always switches on in the mode
most recently used (e.g. manual mode
1. Press the button 13 repeatedly until the
selection menu appears
2. Press on the touch menu
MENU
3. Use / to move to the central fi eld
▲ ▼
STANDBY
outlined in red
4. Press
STANDBY
5. Select the desired time
The setting is accepted immediately.
• In standby mode, the button fl ashes red.
button 16
).
M