Menu Functions; Rapid Mode; Subreflector Sub Refl - Leica SF 64 Mode D'emploi

EN

MENU FUNCTIONS

RAPID
In the
depend on how much light is needed for the shot. If
the fl ash interval is too long, the
be switched on for this. It is particularly recommend-
ed in cases where rapid fl ash intervals are more
important than maximum fl ash output, e.g. in
relatively small rooms. However, the guide number is
reduced by 1 stage, e.g. from guide number 36 (at
ISO 100, zoom 35) to guide number 25 (at ISO 100,
zoom 35).
Setting procedure
1. Press the
2. Press the sensor button
3. Use
4. Press
5. Press
74
MENU
MODE
and fl ash modes, the fl ash intervals
A TTL
RAPID
button 13 repeatedly until the
selection menu is listed
on the touch
MENU
display
▲ / ▼ to move to the central fi eld
RAPID
outlined in red
RAPID
or to switch the function on or off
ON OFF
The selected setting is accepted immediately. The selected setting is accepted immediately.
• After the function has been activated,
shown on the display.
function can
is
SUB REFLECTOR
SUB-REFL.
The sub refl ector is used for front lighting with
4
indirect fl ash if the main refl ector has been pivoted to
the side or up. If the amount of light from the sub
refl ector is too much, it can be reduced by half.
Setting procedure
1. Press the button 13 repeatedly until the
selection menu appears
2. Press the sensor button on the touch
MENU
menu
3. Use ▲ / ▼ to move to the central fi eld
SUB REFL
outlined in red
4. Press
SUB-REFL.
5. Press or to select the desired output
1/1 1/2
stage or to switch off the sub refl ector
OFF
The selected setting is accepted immediately. The selected setting is accepted immediately.
• After the sub refl ector has been activated,
appears in the display. appears in the display.
.
In the menu or
INFO 1/1
represents full output and
1/1
is displayed.
1/2
half output.
1/2