Adjusting The Arm Support; Maintenance; Regular Maintenance - Vermeiren V100 Mode D'emploi

N
3.7

Adjusting the arm support

The arm support of your wheelchair can be adjustable in height and depth. The height of the
arm support can be adjusted in 3 positions.
Height armsupport to seat Number of the blocks
220 mm (8.66 in.) (Standard)
230 mm (9.06 in.)
240 mm (9.45 in.)
The depth of the armrest can be adjusted in 3 positions.
Depth of the armrest
Front position
Middle position (Standard)
Back position
Adjust the height and the depth of the armrest as follow:
1. Remove both screws under the armrest.
2. Place the correct number of blocks under and above the tubes, see table 4.
3. Install the armrest with the required holes for depth adjustment.
4

Maintenance

The expected lifetime of this wheelchair amounts 8 years. Lifetime of the wheelchair is
influenced by its use, storage, regular maintenance, servicing and cleaning.
4.1

Regular Maintenance

The maintenance activities to ensure a good condition for your Vermeiren wheelchair are
described below:
Before every ride




Table 4: Height of arm support
Table 5: Depth of armrest
Check the tyres and make them clean. If necessary change the tire.
Check screw fastenings are secured.
Check the brakes and adjusted if necessary.
Check the wheelchair (cleanliness, cracks, damage on structural parts ... .)
and make it clean. If necessary change the coating.
Number of blocks between
under the tube
2
1
0
Used holes
Back and middle
Hole 2 and 4
Front and middle
Page 18
V100
2011-01
tube and armrests
1
2
3