Preparing The Outside Air Connection; Installing And Connecting - Dovre BOLD 300 Installation Et Mode D'emploi

2. Remove the cover (7) from the back wall by remov-
ing the nut (6) and the clamping bracket (9).
3. Remove the cover (7) and the seal (8).
Check that the sealing tape on the contact sur-
face is not damaged. Replace the sealing tape
if it is damaged.
4. Disassemble the connecting collar (2) by undoing
the bolts (1).
5. Remove the connection collar (2), the seal (3) and
the materials supplied (1, 5, 6).
Check that the sealing tape on the contact sur-
face is not damaged. Replace the sealing tape
if it is damaged.
6. Remove the brake plate (4).
Assembly (see drawing below)
10
7
8
9
6 5 2
11
1. Remove the top plate (A). First remove the two
nuts (11).
2. Assemble the decorative cover (B) using the
materials supplied (C).
3. Fit the connecting collar (2), the seal (3) and the
brake plate (4) with the materials supplied (1, 5, 6)
on the back wall
4. Assemble the connection collar (7) and the seal (4)
with the materials supplied (8, 9, 5, 6).
5. Place the top plate (A) with assembled decorative
cover (B) on the appliance and note the positioning
ridges.
Subject to change because of technical improvements.
A
B
C
5
6
4
3
1
09-20021-101
6. Replace the top plate and screw it tightly using the
nuts (2).
7. Replace the baffle plate (1).
Preparing the outside air
connection
If the appliance is installed in a room with insufficient
ventilation, you can install the outside air connecting
kit to the appliance.
The air supply tube is 100 mm in diameter. If the tube
is smooth, it may be no longer than 12 metres. If
accessories such as bends are used, the maximum
length (12 m) must be reduced by 1 m for each access-
ory used.
Outside air connection via the wall
1. Make an opening in the wall (see the appendix,
"Measurements", for the correct position of the
opening).
2. Close the air connection hermetically to the wall.

Installing and connecting

1. Position the appliance in the correct place, and
make sure it is level. The appliance is designed
with adjustable feet, which may already be moun-
ted on the appliance or be included. Use these
adjustable feet so that the appliance can be placed
perfectly level.
1
2
09-20021-089
9