Preparing The Outside Air Connection - Dovre Sonata Installation Et Mode D'emploi

Connect to top
1. Apply supplied fibre glass sealing tape (3)
measuring 10 x 3 mm to the contact surface of the
connection collar (2).
2. Fit the connection collar to the inner top plate with
the materials supplied (1), (4) and (5).
3. Apply supplied fibre glass sealing tape (7)
measuring 10 x 3 mm to the contact surface of the
cover (8).
4. Fit the cover to the inner top plate with the
materials supplied (6).
Subject to change because of technical improvements
Preparing the outside air
connection
If the appliance is installed in a room without sufficient
ventilation, you can install the connecting kit on the
appliance for the supply of outside air.
The air supply tube is 100 mm in diameter. If using a
smooth tube, it may be no longer than 12 metres long.
If accessories such as bends are used, the maximum
length (12 metres)) must be reduced by 1 metre for
each accessory used.
Outside air connection via the wall
1. Make an opening in the wall (see the appendix,
"Measurements", for the correct position of the
opening).
2. Close the air connection hermetically to the wall.
3. Seal off the air connection hermetically to the
connection collar (1) from the outside air supply;
see following figure.
9