Preparing The Outside Air Connection; Installing And Connecting - Dovre ROCK 350 Installation Et Mode D'emploi

Assembly (see drawing below)
6
7
8
9
15
1. Remove the top plate (1).
2. Assemble the decorative cover (2) using the
materials supplied (3).
3. Assemble the connection collar (4) and the seal (5)
with the materials supplied (6, 7, 8, 9).
4. Place the top plate (1) with assembled decorative
cover (2) on the appliance.
5. Fit the connecting collar (11), the seal (12) on the
back wall with the attachment materials (10, 14,
15)
Preparing the outside air
connection
If the appliance is installed in a room with insufficient
ventilation, you can install the outside air connecting
kit to the appliance.
The air supply tube is 100 mm in diameter. If the tube
is smooth, it may be no longer than 12 metres. If
accessories such as bends are used, the maximum
length (12 m) must be reduced by 1 m for each access-
ory used.
Subject to change because of technical improvements
1
2
3
4
5
12 11
14 10
09-20021-157
Outside air connection via the wall
1. Make an opening in the wall (see the appendix,
"Measurements", for the correct position of the
opening).
2. Close the air connection hermetically to the wall.

Installing and connecting

1. Position the appliance in the correct place, and
make sure it is level. The appliance is designed
with adjustable feet, which may already be
mounted on the appliance or be included. Use
these adjustable feet so that the appliance can be
placed perfectly level.
2. If the appliance is to be placed on a smooth floor,
the four anti-slip pads can be placed beneath the
adjustable feet to prevent the appliance from
moving, see next image.
3. Connect the appliance to the flue hermetically.
4. For outside air supply connection: connect the
outside air supply to the connection kit which is
fitted to the appliance.
1
09-20021-156
09-20500-015
13