Burning Wood - Dovre BOLD 300 Installation Et Mode D'emploi

some smoke may escape into the room instead of up
the chimney. You can avoid this problem by lighting
the fire as described below.
1. Stack two layers of medium sized logs crosswise.
2. Stack two to three layers of kindling crosswise on
top of the logs.
3. Place a firelighter between the bottom layer of kind-
ling and light the firelighter according to the instruc-
tions on the packaging.
4. Close the appliance door and open the primary
and secondary air inlets; see the following figure.
5. Allow the fire develop into a good blaze until there
is a glowing bed of charcoal. You can then add fuel
and adjust the appliance, see the chapter "Stoking
with wood".
Subject to change because of technical improvements.
09-20500-016
C:
o o o Primary air open (when lighting the stove)
o o Secondary air open (glass wash)
o
B:
o o Secondary air open (glass wash)
o
A:
o

Burning wood

After you have followed the instructions for lighting:
1. Slowly open the door of the appliance.
2. Spread the charcoal evenly across the bottom of
the stove base.
3. Stack a few logs on the charcoal.
B
A
09-20021-096
Air for post-combustion open
Air for post-combustion open
Air for post-combustion open
(never close entirely for proper combustion)
C
11