Preparing The Connection To The Flue - Dovre TAI 35WT Installation Et Mode D'emploi

1. Remove the stove from the pallet by removing the
bolts (1).
2. Tip the stove to the rear.
3. Remove the mounting brackets (2).
4. Fit the four legs on the studs using the washers
and the M8 nuts that are found on the bottom
plate.
5. Set the appliance upright on the mounted legs.
Support the appliance when placing it upright
so that not all the weight is not on the legs.
Preparing the connection to
the flue
When connecting the appliance to the flue you have
the choice of connecting via either the top or the rear.
See the paragraphs "Connecting to the rear" and "Con-
necting to the top".
Connecting to the rear
1. Remove the connection collars (2) and the sealant
(3) from the top of the stove.
2. Remove the protection plate from the back shield
with the assistance of a screwdriver; see following
figure.
12
1
2
3
09-20020-367
3. Remove the cover (6) from the back wall.
4. Fit the connection collar (2) and the sealant (3) to
5. Fit the cover (6) to the top plate using mounting
Connecting to the top
As standard, the appliance is delivered with the con-
nection collar fitted for a connection at the top, see fol-
lowing figure.
On delivery, the connection at the rear is closed, so
that a back cover does not need to be installed.
the back wall using the materials supplied (1,4,5).
materials (4,5,7,8).
6
7
3
8
4
5
1 2 3 4
Subject to change because of technical improvements
09-20020-364
5
09-20020-371