Preparing The Connection To The Outside Air - Dovre 525CB Mode D'emploi Et Installation

3. Remove the cover from the back wall.
4. Install the connection collar to the back wall with
the materials.
5. Install the cover (1) with mounting bracket (4) in
the top plate.
1
2
5
6
Subject to change because of technical improvements
Installation
Connect to top
Upon provision, the connection is fitted at the back,
therefore you need not install a cover on the back.
wall, the protection plate may not be removed in the
back shield.
1. Apply supplied fibre glass sealing tape (3)
2. Attach the connection collar to the top plate with
09-20008-005
3
4
7 2 8
Preparing the connection to
the outside air
9 10
If the appliance is installed in a room without sufficient
ventilation, you can install the connecting kit on the
appliance for the supply of outside air.
09-20008-006 The air supply tube has a diameter of 100 mm. If
installing a smooth tube, it may be no longer than 12
m. If accessories such as bends are used, the
maximum length (12 m) must be reduced by 1 m for
each accessory used.
Because of the distance to the (combustible)
measuring 10 x 3 mm to the contact surface of the
connection collar (2).
the materials supplied.
1
2
3
4
5
09-20008-007
7