Dmx Controller; Dmx 512 Configuration; Dmx 512 Connection - Nicols POWER FLOWER Manuel D'utilisation

Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Mode Sound (LED OFF)

5.3 DMX Controller

By using a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
ENTER button and the display will blink. Use DOWN and UP button to change the
DMX512 address. Once the address has been selected, press and keep ENTER button
pressed up to when the display stops blinking or storing automatically 8 seconds later. To
go back to the functions without any change press the MENU button again. If you use
please refer to the following diagram to address your DMX512 channel for the first 4 units：

6. DMX 512 Configuration

7. DMX 512 Connection

The DMX 512 is widely used in intelligent lightings and with a maximum of 512 channels.
Show
1-8
Show (LED Slow Blinking)
25-
1. Press to select color
2. Hold to select gobo
LED ON
is showing on the display. Pressing