Safety Instruction - Nicols POWER FLOWER Manuel D'utilisation

1. Safety Instruction

Please read the instruction carefully which including important information about
the installation, operation and maintenance.

Please keep this User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.

Unpack and check carefully there is no transportation damage before using the unit.

Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric

shock.

The unit is for indoor use only and use only in a dry location.

The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.

Disconnect mains power before fuse replacement or servicing.

Replace fuse only with the same type.

Make sure there are not flammable materials close to the unit while operating as it is
fire hazard.

Use safety cable when fixes this unit.
Maximum ambient temperature is TA: 40 ℃ and don't operate it where the

temperature is higher than this.
Unit surface temperature may reach up to 60℃. Don't touch the housing bare-hand

during its operation.

There are no user serviceable parts inside the fixture. Do not open the housing or
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact the nearest authorized technical assistance center and always use the
same type spare parts. .
Don't connect the device to any dimmer pack or power pack.


The housing must be replaced if they are visibly damaged.

Do not touch any wire during operation as high voltage might be causing electric
shock.

Please do not look at the beam light directly in order NOT to have visual problems.

Please pay attention to the LED emissions that can hurt or irritate eyes.
16-