2-light show
In slave mode,
means the unit works as the master unit and
show. In order to create a great light show, you can set
contrast movement to each other, even if you have two units only.
5.2 Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. There is a
terminator for connect the easy controller inside the fixture. By connecting
the cable into DMX IN waterproof cable entry gland to the CA-8 terminator
of the first fixture, you will find that the remote control on the first fixture will
control all the other fixtures for Stand by, Function and Mode functions.
Blackout
Blackout the unit
1. SynchroStrobe
Select Show
Function
2. Asynchro Strobe
(Show 1-8)
3. Sound Strobe
Sound/Strobe
Show
Mode
(LED OFF)
(LED ON)
5.3 DMX Controller
Using universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512
address. Once the address has been selected, press and keep ENTER button pressed up
to when the display stops blinking or storing automatically 8 seconds later. To go back to
the functions without any change press the MENU button again. If you use please refer to
the following diagram to address your DMX512 channel for the first 4 /2 units.
1 channel mode:
3 channels mode:
means 2-light
on the second unit to get
Select Speed
4.
Slow
5.
Middle
6.
Fast
LED blinking
is showing on the display. Pressing ENTER
20
6. DMX512 Configuration
1 & 3-CH modes:
7. DMX512 Connections
The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
1. Connect the fixture together in a "daisy chain" by XLR plug cable from the output of the
fixture to the input of the next fixture. The cable cannot be branched or split to a "Y"
21