DMX 512 Address Setting
Press the MENU button up to when the
ENTER button and the display will blink. Use DOWN and UP button to change the
DMX512 address. Once the address has been selected, press the ENTER button to setup.
To go back to the functions without any change press the MENU button again. Hold and
press the MENU button about 2 seconds or wait for 60 seconds to exit the menu mode.
Slave Mode
Press the MENU button up to when the
ENTER button and the display will blink. Use DOWN and UP button to select the
(Slave 1) or
ENTER button to setup. To go back to the functions without any change press the MENU
button again. Hold and press the MENU button about 2 seconds or wait for 60 seconds to
exit the menu mode..
Show Mode
Press the MENU button up to when the
ENTER button, Use the DOWN and UP buttons to select the
(show 1) or
been selected, press the ENTER button to setup. To go back to the functions without any
change press the MENU button again. Hold and press the MENU button about 2 seconds
or wait for 60 seconds to exit the menu mode.
Split Color Mode
Press the MENU button to show
display will blink. Use the DOWN and UP button to select the
(normal) mode. Once the mode has been selected, press the ENTER button to
setup. To go back to the functions without any change press the MENU button again. Hold
and press the MENU button about 2 seconds or wait for 60 seconds to exit the menu
mode.
Dimmer Calibrate
Press the MENU button to show
display will blink. Use the DOWN and UP button to calibrate the dimmer for a maximum
(
)
slave 2
mode. Once the mode has been selected, press the
(Show 2) or ... or
is showing on the display. Pressing
is showing on the display. Pressing
is shown on the display. Pressing the
(show 8). Once the mode has
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
21-
(Random show) or
(Split color mode) or