How To Control The Unit; Master/Slave Built-In Preprogram Function; Easy Controller; Universal Dmx Controller - Nicols LED BAR 1241 RGBW Manuel D'utilisation

Manual Test
Press the MENU button up to when the Manual Test is showing on the display. Press
ENTER button and Red 1 will blink, use UP and DOWN button to choose Green 1 or Blue 1
or White/Amber 1 or Red2 or ... or White/Amber 4 or Dimmer or Strobe, press ENTER
button to enter, then press UP and Down button to adjust the value and press ENTER
button to choose next optional. Back to the main functions without any change please press
the MENU button.
White Balance
Press the MENU button up to when the White Balance is showing on the display. Press
ENTER button and the r 255 will blink, press UP and Down button to adjust the value, press
ENTER button to store and g 255 will blink on the display, press UP and Down button to
adjust the value, press ENTER button to store and b 255 will blink on the display, press UP
and Down button to adjust the value, and press ENTER button to store. Back to the main
functions without any change please press the MENU button.
Fan Speed
Press the MENU button up to when the Fan Speed is showing on the display. Pressing
ENTER button and the display will blink. Use DOWN and UP button to select Auto Speed
(When the temperature of the unit under 40 , FAN stops; between 45 ~55 , FAN runs at
half speed; above 60 , FAN runs at full speed. The LEDs will be off if the temperature
higher than 75 ) or High Speed, press ENTER button to store. To go back to the functions
press the MENU button.
Fixture Temp
Press the MENU button up to when the Fixture Temp is blinking on the display. Pressing
ENTER button and the display will show the temperature of the unit. To go back to the
functions press the MENU button.
Fixture Time
Press the MENU button up to when the Fixture Time is blinking on the display. Pressing
ENTER button and the display will show the number of working hours of the unit. To go back
to the functions press the MENU button.
26-
Firmware Version
Press the MENU button up to when the Firmware Version is blinking on the display.
Pressing ENTER button and the display will show the version of software of the unit. To go
back to the functions press the MENU button.

4. How To Control The Unit

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By universal DMX controller
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show.
2-light show
In slave mode, slave 1 means the unit run as the master unit and slave 2 means 2-light show.
In order to create a great light show, you can set slave 2 on the second unit to get contrast
movement to each other, even if you have two units only.

4.2 Easy Controller

The easy remote control is used only in master/slave mode. By connecting
to the 1/4" microphone jack of the first unit, you will find that the remote
controller on the first unit will control all the other units for Stand by, Function
and Mode selection.
Stand By Blackout the unit
Function 1. Sync. Strobe Select
2. Async strobe Manua Color
3. Sound Strobe or color 1-32
Mode Sound (LED OFF) LED On
4.3 DMX Controller
Using universal DMX controller to control the units, you have to set DMX address from 1 to
Select Select Speed
show 1-8 1. Fast
or Auto fade 2. Middle
3. Slow
Slow blinking Fast blinking
27-