How To Control The Unit - Nicols POWER FLOWER Manuel D'utilisation

Reset
Press the MENU button to show
channels of the unit will return to their standard position.

5. How To Control The Unit

You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Easy controller
3. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effect at once. Every time you turn the unit on, it will show
display and move all the motors to their 'home' position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built in
programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when
you want an instant show. Its DMX input jack will have nothing plugged into it, and Its
master LED will be constantly on and sound LED will flash to the music. The other units
will have to set in slave mode
mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led
lights will constantly on.
2-light show
In (slave mode),
2-light show. In order to create a great light show, you can set
to get contrast movement to each other, even if you have two units only.
5.2 Easy Controller (by CA-8/CA-9/CA-9RTX)
The easy remote control is used only in master/slave mode. By connecting to
the 4-pin jack of the first unit, you will find that the remote controller on the first
unit will control all the other units for Stand by, Function and Mode selection
on the display. Press the ENTER button and all
and select
means the unit works normally and
24-
(Slave 1) or
on the second unit
on the
( )
slave 2
means