Nicols POWER FLOWER Manuel D'utilisation page 24

Self-Test
Press the MENU button to show
unit will run self-test by built-in program. To go back to the functions without any change
press the MENU button again. Hold and press the MENU button about 2 seconds or wait for
60 seconds to exit the menu mode.
Temperature Test
Press the MENU button to show
display will show the temperature of the unit. To go back to the functions without any
change press the MENU button again. Hold and press the MENU button about 2 seconds
or wait for 60 seconds to exit the menu mode.
Fixture Hours
Press the MENU button to show
display will show the number of working hours of the unit. To go back to the functions
without any change press the MENU button again. Hold and press the MENU button about
2 seconds or wait for 60 seconds to exit the menu mode.
Software version
Press the MENU button to show
display will show the version of software of the unit. To go back to the functions without
any change press the MENU button again. Hold and press the MENU button about 2
seconds or wait for 60 seconds to exit the menu mode.
PRO Defaults
Press the MENU button to show
display will blink. Use the DOWN and UP button to select the
to set the fixture to PRO Defaults settings) or
To go back to the functions without any change press the MENU button again. Hold and
press the MENU button about 2 seconds or wait for 60 seconds to exit the menu mode.
Display inversion mode for the fixture fixing under ceiling.
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
. Press the ENTER button to setup.
23-
(run built-in program