Nicols POWER FLOWER Manuel D'utilisation page 23

output from
is not limited). Once the mode has been selected, press the ENTER button to setup. To go
back to the functions without any change press the MENU button again. Hold and press the
MENU button about 2 seconds or wait for 60 seconds to exit the menu mode.
Sound Mode
Press the MENU button to show
display will blink. Use the DOWN and UP button to select the
(sound off) mode. Once the mode has been selected, press the ENTER button to setup. To
go back to the functions without any change press the MENU button again. Hold and press
the MENU button about 2 seconds or wait for 60 seconds to exit the menu mode.
Blackout Mode
Press the MENU button to show
display will blink. Use the DOWN and UP button to select the
(no blackout) mode. Once the mode has been selected, press the ENTER button to
setup. To go back to the functions without any change press the MENU button again. Hold
and press the MENU button about 2 seconds or wait for 60 seconds to exit the menu mode.
Led Display
Press the MENU button to show
display will blink. Use the DOWN and UP button to select the
(Led off) mode. Once the mode has been selected, press the ENTER button to setup. To
go back to the functions without any change press the MENU button again. Hold and
press the MENU button about 2 seconds or wait for 60 seconds to exit the menu mode.
Display Inversion
It is good for you to install the unit on the floor or under ceiling. Press the MENU button to
show on the display. Press the ENTER button to change to the mode
(display normal), It will automatically store after 8 seconds. Or press the ENTER button
again return to the mode
any change press the MENU button again. Hold and press the MENU button about 2
seconds or wait for 60 seconds to exit the menu mode.
(limited to 50% of the really max. output) to
(display inversion). To go back to the functions without
Display normal mode for the fixture putting on the floor.
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
on the display. Press the ENTER button and the
22-
(maximum output
(sound on) or
(yes blackout) or
(Led on) or