Master/Slave Operation; Universal Dmx Controller; Dmx 512 Configuration - Nicols ZAP LED DMX Manuel D'utilisation

A. Master/Slave operation
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in
jack will have nothing plugged into it, and it's master LED will be constantly on and sound
LED will flash to the music. The other units will have to set in slave mode and select
(normal) or (2 light show) or
Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led lights will
constantly on.
2-light show
In slave mode, means the unit works normally and
order to create a great light show, you can set
movement to each other, even if you have two units only.
B. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. By connecting
to the 1/4" microphone jack of the first unit (its DMX input plug is not used),
you will find that the remote control all the first unit will control all the other
units for Stand by, Function and Mode. Built-in lighting shows triggered by
Easy Controller:
Stand by Blackout the unit
1. Strobe
2. Sound Synchronous Strobe
Function
3. Sound Asynchronous Strobe
Strobe
Mode
(LED OFF)
C. Universal DMX controller
If you use a universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
(master) mode. Its DMX input
(3 light show) or (4 light show) mode,
means 2-light show. In
on the second unit to get contrast
Slow Show Fast Show
12 12
Latch Latch
(LED slow blinking) (LED ON)
is shown on the display. Pressing ENTER
20-
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the MENU button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
3 Channels:
9 Channels:
:
28 Channels

6. DMX 512 Configuration

3 channels mode:
21-