Dmx512 Configuration; Dmx Controller; Dmx512 Connections - Nicols GALACTIC LED Manuel D'utilisation

fixtures for Stand by, Function and Mode functions.
Blackout Blackout the unit
1. White Strobe
2. Color Strobe Select Color
Function
3. Sound White Strobe (Color 1-15)
4. Sound Color Strobe
Sound/Strobe
Show
Mode
(LED OFF)
(LED ON)

4.3 DMX Controller

Using universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the MENU button again.
If you use please refer to the following diagram to address your DMX512 channel for the first
4/2 units.
1 channel:
4 channels:
10 channels:
Select Speed
Select Show 4. Fast
(Show 1-16) 5. Middle
6. Slow
LED slow blinking LED fast blinking
is showing on the display. Pressing ENTER
20-

5. DMX512 Configuration

1 & 4-CH modes:
256-CH mode:
4 channels as a group, please refer to the DMX configuration of 1-4 channels to control the
other channels when you choose 256 channels mode. Under this mode, you can control the
256 LEDs separately.

6. DMX512 Connections

The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
21-