How To Control The Unit; Master/Slave; Dmx Controller - Nicols IP WASH 270 FC Manuel D'utilisation

button to setup or exit menu mode without any change after one minute. Back to the functions without any change press MENU button
again.
Self-Test
Press the MENU button up to when the
program. To go back to the functions press the MENU button again.
Temperature Test
Press the MENU button up to when the
temperature of the unit. To go back to the functions press the MENU button again.
Fixture Hours
Press the MENU button up to when the
of working hours of the unit. To go back to the functions press the MENU button.
Software version
Press the MENU button up to when the
of software of the unit. To go back to the functions press the MENU button again.
4.

How To Control The Unit

You can operate the unit in 2 ways:
1. By master/slave built-in preprogram function
2. By DMX controller
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an automatic, synchronized light show.
This function is good when you want an instant show. In Master/Slave mode, the first fixture whose DMX input jack has with nothing
connect will be master automatically, set other units to slave mode

4.2 DMX Controller

Use universal DMX controller to control the units, you have to set DMX address from 1 to 512 channel so that the units can receive
DMX signal.
Press the MENU button up to when the
DOWN and UP button to change the DMX512 address. Once the address has been selected, press and keep ENTER button pressed
up to when the display stops blinking or storing automatically 8 seconds later. To go back to the functions without any change press
the MENU button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units
4 Channels：
7 Channels：
5 Channels：
is blinking on the display. Press ENTER button and the unit will run self-test by built-in
is blinking on the display. Press ENTER button and the display will show the
is blinking on the display. Press ENTER button and the display will show the number
is blinking on the display. Press ENTER button and the display will show the version
.
is showing on the display. Pressing ENTER button and the display will blink. Use
16
：