Horizon Hobby Dynamite FUZE Manuel D'utilisation page 8

EN
7. Motor Timing
There are 4 options
available in this
function that allow you
to adjust motor timing
to maximize your
motor's performance.
The options are: auto,
low, standard and
advanced. Advanced
timing offers
maximum power
output at the expense
of efficiency and run
time.
8. Battery
Management
System/Low
Voltage Cutoff
The battery
management sytem
allows you to protect
your batteries from
damage due to over-
discharge. Six total
options are available;
3 for Li-Po/Li-Ion
batteries and 3 for Ni-
Cd/Ni-MH batteries.
More about the Battery
Management System/Low
Voltage Cutoff
The low-voltage cutoff is based on the type of
battery, battery voltage, cell count (for Li-Po/
Li-ion modes, which the ESC recognizes at power
up) and battery voltage under load. The low-
voltage cutoff occurs in 2 steps.
8
In motor timing mode, the motor produces 7
beeps signifying motor timing mode, followed
by 1 to 4 beeps signifying the available
options:
7 beeps–1 beep auto motor timing
(factory default)
7 beeps–2 beeps low motor timing
7 beeps–3 beeps standard motor timing
7 beeps–4 beeps advanced motor timing
In battery management system mode, the
motor produces 8 beeps signifying battery
management system mode, followed by 1 to 6
beeps signifying the available options:
8 beeps–1 beep N i-Cd/Ni-MH 4.5V cutoff
(factory default)
8 beeps–2 beeps N i-Cd/Ni-MH 4.2V cutoff
8 beeps–3 beeps N i-Cd/Ni-MH 3.9V cutoff
8 beeps–4 beeps L i-Po/Li-Ion light discharge
8 beeps–5 beeps L i-Po/Li-Ion standard
discharge
8 beeps–6 beeps L i-Po/Li-Ion heavy
discharge
Step 1: The motor's power is reduced in order to
alert the user that the battery is about to reach the
cutoff point.
Step 2: Once the battery reaches the low-voltage
cutoff point, the motor will shut down completely.
In order to protect your battery, do not resume
operation. Shut the vehicle off and install a
fully charged battery.
The following will show the low-voltage
cutoff levels:
Once the series of
beeps for the option
you wish to choose
has completed, move
the throttle position to
maximum and release to
neutral. You will receive
a 4-beep confirmation of
programming. If at this
time you do not wish
to proceed to the next
function, you can simply
shut the power off to
the ESC.