General; Building-In Dimensions; Cooker Hoods With A Visor - Pelgrim SLK 700 Notice D'utilisation

General

This appliance should be connected to the
power supply by a recognized fitter who is
familiar with, and works according to the
correct safety regulations.
Important that you know
If the cooker hood is to be fitted to an
existing duct no other appliances, such as
a geyser or heater, may be connected to
that same duct.
Consider local regulations with respect to
the ventilation of gas appliances!
The cooker hood should be mounted at
least 650 mm above the hob.
The shorter the duct, and the fewer the
bends in it, the better the cooker hood will
work.
Before you start drilling check that there
are no installation cables present.

Building-in dimensions

ø
256
454
148
525
286
ISW 700
598
510
420
ø150
60
120
95
140
40
295
200
SLK 810
598
510
ø 125
202
150
40
265
200
SLK 700/ MSL 140
598 (898)
510 (810)
Ø 125
150
175
95
40
265
200
SLK 750/950

Cooker hoods with a visor

Mounting the cooker hood
H
G
Fig. 8. Mounting
Drill 4 holes in the bottom of the wall
cupboard, using the stencil provided (H). Also
saw the hole for the duct.
Using the 4 screws supplied, fix the cooker
hood to the bottom of the cupboard. Make sure
that the front of the cooker hood does not stick
out in front of the side of the cupboard (G).
The handle may be replaced by other material,
e.g. the same material used for the kitchen
cupboards or the light strip. The handle is
fitted from the back with screws.
A
P
Fig. 9. Extraction
Connect the cooker hood outlet flange (P) to
the duct (A). Put the plug in the wall socket.
Mounting the cover
Fig. 10. Cover
If the cupboard is deeper than the cooker
hood, you can mount the cover via the slotted
holes on the back of the hood. The depth can
be adjusted from 35 to 85 mm.