Staufenbiel Hyperion HSF0314092E Instructions De Montage page 15

03
04
05
06
Adjust the length of the rudder-linkage by
screwing or unscrewing the clevis to the linka-
ge. Use the M2 nut to tighten the clevis. Addi-
tionally we recommend using thread lock. Af-
terwards mount the clevis to the rudder horn
like shown in the picture.
Adjust the length of the elevator-linkage by
screwing or unscrewing the clevis to the linka-
ge. Use the M2 nut to tighten the clevis. Ad-
ditionally we recommend using thread lock.
Afterwards mount the clevis to the elevator
bellcrank like shown in the picture. The right
side of the bellcrank should be vertical in neu-
tral position.
If you want to build a removeable servotray
prepare two pine ridges.
Attach in the back of the ridge a drive in nut
and glue it with CA Glue.
EN
15