Wiring; Condensate Drain; Testing - Webstaurant Store 3299720 Manuel D'utilisation Et D'installation

The connection to power supply may be carried out at the back of the appliance after
removing the protection grid.
All wiring cables are to comply with the ratings shown on the technical specifications
Cables are to be connected to the no potential difference terminal.
The grounding cable is to be directly connected to a good grounding system.
The guarantee will cease and the Manufacturer will not be liable for any damage to appliances or
operators arising from the non-compliance with the and tamperings to any part of the appliance
(electric, thermodynamic or hydraulic plant).
The equipment has a condensation collection tray. The tray is extractable from the lower part of the
equipment.
Should the appliance have been transported horizontally instead of a vertical position DO NOT START THE
APPLIANCE IMMEDIATELY. WAIT FOR AT LEAST 24 HOURS BEFORE OPERATING.
The manufacturer declines any responsibility and any warranty obligation if damage occurs to the
equipment imputable to transportation in a horizontal position.
Carry out the following checkings:
1) Outside temperatures must be included between 59°F and 100°F.
2) Turn on the appliance and wait 30 minutes before the use if the external temperature is "low".
3) Check power input
4) Carry out at least one full quick cooling cycle

WIRING

CONDENSATE DRAIN

TESTING

11
3299720 /160555_GB