Machine's Starting - breviglieri mini master Manuel D'utilisation Et D'entretien

mini master
macchine agricole

Machine's starting

Machine's starting, choise of the tractor :
Before starting the machine, read this instructions manual carefully and keep it with care and within reach, in case you will need
to consult it.
The machine must be fixed to the tractor with a three point linkage of suitable category with 540 rpm power take off .
Never exceed the maximum weights allowed on the needed information on the tractor's instruction manual, or ask them to the
builder itself .
The tractor must be equipped with two auxiliary control valves; (with four quick couplings , 1/2 BSP Din standard ).
After having installed the machine , fix the elevator with its chains or fixing bars .
Attention : do not stand near the three point linkage area of the tractors because there is danger of buckling; do not stand near
this area when the elevator is operating .
Connect the machine's quick couplings to the tractor's quick couplings, following the diagram below ; before starting working,
make some test manoeuvres to verify if the connection is right .
After having installed the machine, connect it to the tractor's power takeoff throught a cardan shaft of suitable class and lenght .
For the cardan shaft's connection, use and service, read the builder's instruction carefully.
Use only EC certified cardan shaft .
The cardan shaft's telescopic tubes must be used with a maximum extension of 2/3 of the total length .
The power takeoff's protection and the cardan shaft's one must be overlapped at least 50 mm.
Hook the protection's anti-rotation chains.
After the use, when you put the cardan shaft away, pay attention not to damage the protections
Before the machine's starting, check the general greasing, and disconnect the locks for the transport .
- 15 -