Checklist Before Installation; Installation In A Wall - Petsafe Passport MPA19-13800 Guide D'installation

Installation

Checklist Before Installation

Before installing the Passport
… Clock battery is installed.
… If using the power adaptor, you have located a power outlet in planned location on inside of home where
power adaptor can plug in. If not, you have a power cord extension to reach the outlet or are using the
optional Passport Rechargeable Battery instead (sold separately) as the power source.
™
… Planned location has been checked for possible radio-frequency interference by ensuring all common
household appliances and electronic devices are at least 2 feet (60 cm) away.
… Power adaptor and motion sensor wire have been disconnected or if using optional Passport
Battery, it has been removed.
… "Initial User Setup" steps to set the language, time and date have been completed.
… Each pet to use the Passport
… Each Passport Key has been tested in the installation location on both interior and exterior side and the
™
Passport can read each key.
™
… If installing in a door, will any components of the Passport
… If installing in a wall, are there any objects (such as doors, shrubs, heat pump, etc.) that could obstruct the
Passport once installed?
™
… If installing in a wall, have you checked for electrical and plumbing fixtures in the wall where you plan to install
the Passport ?
™
… You have read the entire Passport
… All steps under "Prepare, Setup and Test" in the Passport
followed and completed.
Want Professional Installation Help? (available in the U.S.A. only)
Invisible Fence Brand installers (where available) may come to your home and install your new
®
PetSafe Pet Door for an additional cost. Contact the Invisible Fence
®
1-877-866-DOGS (3647) or visit the website at www.invisiblefence.com for more information.
• Read this entire guide prior to cutting or modifying an opening in your door or wall.
Do not proceed with cut-out or installation until your Passport
up, programmed for your pet, and all steps under "Prepare, Setup and Test" have
been completed.
• If homeowner's door or other application is not level, the pet door must be installed
level to swing properly.
Note: This Wall Entry Kit is designed to be used with the Passport
two people. Prior to installation, set pet door to Open Mode (see "Door Operational Modes" in the
Passport Operating Guide). After setting to Open Mode, make sure the power adaptor is disconnected
™
(or optional battery is removed if using) and motion sensor wire is disconnected from exterior frame.
6
, it is important to consider the following:
™
has a Passport Key and is successfully programmed to the pet door.
™ ™
Installation and Operating Guides.
™

InStAllAtIon In A WAll

www.petsafe.net
be obstructed by the door opening and closing?
™
Installation and Operating Guides have been
™
Brand Customer Care Center at
®
. This installation will be easier with
™
Rechargeable
™
is assembled, powered
™